[Sense[1]]|Sense2:Limit:fcount - HP E4418B Programming Manual

SENSe Subsystem

[SENSe[1]]|SENSe2:LIMit:FCOunt?

[SENSe[1]]|SENSe2:LIMit:FCOunt?
This query is used to return the total number of limit failures for the
specified channel.
If the appropriate STATe commands are set to ON, each time a
measurement is initiated on the specified channel and the measurement
result is outside the limits, the counter is incremented by one.
If the measured value is equal to a limit, this is a limit pass.
The counter is reset to zero by any of the following commands:
When [SENSe[1]]|SENSe2:LIMit:CLEar:AUTO is set to ON, the
counter is set to zero each time a measurement:
When [SENSe[1]]|SENSe2:LIMit:CLEar:AUTO is set to ONCE, the
counter is set to zero the first time a measurement:
The maximum number of errors is 2
detected the counter returns to zero.
9-44
•
*RST
•
[SENSe[1]]|SENSe2:LIMit:CLEar:IMMediate
•
[SENSe[1]]|SENSe2:LIMit:CLEar:AUTO ON
• is measured using MEASure?
• is read using READ?
• is initiated using:
INITiate[:IMMediate] or,
INITiate:CONTinuous ON.
• is measured using MEASure?
• is read using READ?
• is initiated using:
INITiate[:IMMediate] or,
INITiate:CONTinuous ON.
16 16
-1. If more than 2
HP E4418B/E4419B Programming Guide
-1 errors are