HP E4418B Programming Manual page 34

Power Meter Remote Operation
Configuring the Remote Interface
Command
OC1
OS
PR
RA
RC
RH
RL0
RL1
RM
RV
SM
2
SPD 20|40
ST
SYST:LANG SCPI
4
TK?
TR0
TR1
TR2
TR3
ZE
@1
?ID
1. This command is accepted but has no active function.
2. This command is not an original HP 438A command. However, it can be used to
set the measurement speed to 20 or 40 readings/sec in HP 438A mode. See
SENSE:SPEED for more details.
3. This command is not an original HP 438A command. However, it can be used to
terminate the HP 438A language and select the SCPI language. Note that it is
recommended that the instrument is Preset following a language switch.
4. This command is not an original HP 437B command. However, it can be used to
allow the last measurement result to be transmitted. This is equivalent to
sending the power meter talk address in HP-IB mode to fetch the last reading
(provided no query is pending).
1-10
Description
Reference oscillator on
Enter offset value
Preset
Auto range
Recall instrument configuration
Range hold
Exit from relative mode
Enter relative mode (take new reference)
Set measurement range
Read service request mask
Status message
20 or 40 readings/sec
Store (save) power meter configuration
3
Selects SCPI language
Last measurement result transmitted
Trigger hold
Trigger immediate
Trigger with delay
Trigger free run
Zero
Prefix for status mask
Identification query
HP E4418B/E4419B Programming Guide