HP E4418B Programming Manual page 364

:ENABle <NRf>|<non-decimal numeric>
This command is used to set the Enable Register of the particular SCPI
Register Set you require to control. The parameter value, when rounded to
an integer and expressed in base 2 has it's first 15 bits written into the
Enable Register of the SCPI Register Set concerned. The last bit (bit 15) is
always set to 0.
Syntax
Parameters
Type
NRf
non-decimal numeric
Query
:ENABle?
The query returns a 15 bit decimal-weighted number representing the
contents of the Enable Register of the SCPI Register Set being queried.
The format of the return is <NR1> in the range of 0 to 32767 (2
HP E4418B/E4419B Programming Guide
space
:ENAB
Status Register Set Commands
NRf
non-decimal numeric
?
Description
The value used to set the
Enable Register.
STATus Subsystem
Range of Values
16
0 to 2 -1
15
-1).
10-5