Installing A Line Card In An Ex9200 Switch; Figure 74: Unpacking A Line Card Used In An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation

Installing a Line Card in an EX9200 Switch

220

Figure 74: Unpacking a Line Card Used in an EX9200 Switch

Installing a Line Card in an EX9200 Switch on page 220
EX9204 Switch Hardware Overview
EX9208 Switch Hardware Overview
EX9214 Switch Hardware Overview on page 3
EX9200 switches have field-replaceable unit (FRU) line cards that can be installed in
the line card slots on the front of the switch chassis. The line cards are hot-insertable
and hot-removable: You can remove and replace them without powering off the switch
or disrupting switch functions. However, we recommend that you take them offline before
removing them.
Before you begin installing a line card in the switch:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage (see "Prevention of Electrostatic Discharge Damage" on page
If there are any transceivers installed in the line card, remove them before you install
the line card. For instructions on removing transceivers, see
on page 237.
Ensure that you know how to handle and store the line card (see
Line Cards in EX9200 Switches" on page
Ensure that you have the following parts and tools available to install a line card in the
switch:
ESD grounding strap
To install a line card in the switch:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the switch chassis.
If the slot has a cover panel on it, rotate the ejector handles simultaneously
2.
counterclockwise to unseat the cover panel.
"Removing a Transceiver"
"Handling and Storing
215).
Copyright © 2017, Juniper Networks, Inc.
329).