Related
Documentation
Installing a DC Power Supply in an EX9214 Switch
Copyright © 2017, Juniper Networks, Inc.
Figure 64: Removing an AC Power Supply from an EX9214 Switch
Let go of the locking pin in the release lever. Ensure that it is seated in the corresponding
6.
hole in the chassis.
WARNING:
Do not touch the connector on the top of the power supply.
Gently pull the power supply out of the chassis.
7.
Installing an AC Power Supply in an EX9214 Switch on page 189
AC Power Supply in an EX9214 Switch on page 45
The DC power supply in an EX9214 switch is a hot-insertable and hot-removable
field-replaceable unit (FRU) installed in the rear panel. Up to four DC power supplies can
be installed in an EX9214 switch.
Chapter 17: Replacing Power Supply
193