Figure 69: Installing An Sf Module In An Ex9200 Switch - Juniper EX9214 Hardware Manual

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
11.3 V bias PEM
11.3 V bias FPD
11.3 V bias POE 0
11.3 V bias POE 1
Bus Revision
FPGA Revision
PMBus Expected
device voltage
XF ASIC A
XF ASIC B
NOTE: The output is of an EX9208 switch. The output is similar for all
EX9200 switches.
Figure 69 on page 211 shows installing an SF module in an EX9208 switch. The procedure
is the same for all EX9200 switches.

Figure 69: Installing an SF Module in an EX9200 Switch

SF
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Removing an SF Module from an EX9200 Switch on page 212
Switch Fabric Module in an EX9200 Switch on page 33
Switch Fabric Module LEDs in an EX9200 Switch on page 40
Chapter 19: Upgrading and Replacing Switch Fabric (SF) Module
11195 mV
11234 mV
11176 mV
11214 mV
64
13
Measured Measured
voltage current
1000 mV 1002 mV 11281 mA
1000 mV 997 mV 11015 mA
Calculated
power
11303 mW
10981 mW
. Failure
211