Configuring Rate Selectability At The Port Level; Table 36: Active Physical Ports On Ex9200-12Qs Line Card Based On The Number-Of-Ports Configuration - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Table 36: Active Physical Ports on EX9200-12QS Line Card Based on the number-of-ports
Configuration
Active Physical Ports for Different Configured Speeds
Ports Configured
(
number-of-ports
Statement) 10-Gigabit
1 0
2 0, 1
3 0, 1, 2
4 0, 1, 2, 3
5 0, 1, 2, 3, 4
6 0, 1, 2, 3, 4, 5

Configuring Rate Selectability at the Port Level

78
To configure rate selectability at the port level:
In configuration mode, navigate to the
1.
hierarchy level.
[edit ]
user@host# edit chassis fpc fpc-slot pic pic-number
For example:
[edit ]
user@host# edit chassis fpc 4 pic 0
To indicate the speed at which the ports operate, configure the
2.
specific ports. The available options are
[edit chassis fpc fpc-slot pic pic-number]
user@host# set port port-number speed (10g | 40g | 100g)
For example:
[edit chassis fpc 4 pic 0]
user@host# set port 0 speed 10g
user@host# set port 1 speed 10g
user@host# set port 2 speed 100g
user@host# set port 3 speed 40g
NOTE: All the six ports of PIC 0 and PIC 1 of an EX9200-12QS support
10-Gbps and 40-Gbps port speeds. However, only ports 2 and 5 of both
the PICs support 100-Gbps speed.
40-Gigabit
0
0, 1
0, 1, 2
0, 1, 2, 3
0, 1, 2, 3, 4
0, 1, 2, 3, 4, 5
[edit chassis fpc fpc-slot pic pic-number]
10g , 40g , and
100-Gigabit
2
2, 5
2, 5
2, 5
2, 5
2, 5
statement for
speed
100g .
Copyright © 2017, Juniper Networks, Inc.