Copyright © 2017, Juniper Networks, Inc.
Figure 8: Craft Interface in an EX9208 Switch
1
8
1—
Host subsystem LEDs
2—
Fan LEDs
3—
Power supply LEDs
4—
Minor alarm LED
5—Major alarm LED
Figure 9: Craft Interface in an EX9214 Switch
1—
Power supply LEDs
2—
Fan LEDs
3—
Host subsystem LEDs
4—
Minor alarm LED
5—
Major alarm LED
NOTE:
You can install a line card or a Switch Fabric module (SF module) in
slot nine—labeled
depending on the hardware installed in that slot.
NOTE:
At least one Switch Fabric module (SF module) with a Routing Engine
module (RE module) must be installed in the switch for the craft interface
to obtain power.
The craft interface has the following components:
Host Subsystem LEDs on page 24
Fan LEDs on page 24
Chapter 2: Chassis Components and Descriptions
2
3
9
6—
Alarm cutoff/lamp test button
7—
Alarm relay contacts
8—
Switch Fabric LEDs and control buttons
9—
Line card LEDs and control buttons
6—
Alarm cutoff/lamp test button
7—
Alarm relay contacts
8—
Line card LEDs and control buttons
9—
Switch Fabric/line card LED and control
button
10—
Switch Fabric LEDs and control buttons
. The corresponding LED displays information
2 | 6
4
5
6
7
23