Figure 15: Ex9200-Re2 Module In An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
32

Figure 15: EX9200-RE2 Module in an EX9200 Switch

1— Extractor clips
2— AUX
Auxiliary port ( )
3— CONSOLE
Console port (
4— MGMT
Management port (
5— ONLINE OK/FAIL
LEDs— ,
Each EX9200-RE2 module consists of the following components:
Extractor clips—Control the locking system to securely install and remove the
EX9200-RE2 module.
port—Connects the EX9200-RE2 module to a modem or other auxiliary device.
AUX
port—Connects the EX9200-RE2 module to a system console through a
CONSOLE
cable with an RJ-45 connector. See
Console or an Auxiliary Device" on page
port—Connects the EX9200-RE2 module through an Ethernet connection to a
MGMT
management LAN (or any other device that plugs into an Ethernet connection) for
out-of-band management. See
Out-of-Band Management" on page
Status LEDs—Indicate the status of the EX9200-RE2 module. Each EX9200-RE2
module has five LEDs labeled
faceplate.
button—Turns the EX9200-RE2 module online or offline when
ONLINE/OFFLINE
pressed.
and ports—Host a removable media interface using which you can install
USB1 USB2
the Junos OS manually. See
page 126.
SSD 1 and SSD 2 slots—Host primary storage for software images, configuration files,
and microcode. Also provide secondary storage for log files and memory dump files.
button—Reboots the EX9200-RE2 module when pressed.
RESET
Captive screws—Secure the EX9200-RE2 module in place.
For the specifications of the Routing Engine modules, see
6— ONLINE/OFFLINE
7—
SSD LEDs—
8—
) USB ports—
9— RESET
)
MASTER 10—
, and SSD slots—
"Connecting an EX9200 Switch to a Management
166.
"Connecting an EX9200 Switch to a Network for
165.
MASTER , ONLINE , OK/FAIL
"USB Port Specifications for an EX Series Switch" on
button
DISK1 DISK2
and
USB1 USB2
and
button
SSD 1 SSD 2
and
, DISK1 , and DISK2 on the
Table 15 on page 33.
Copyright © 2017, Juniper Networks, Inc.