Line Card Components; Ex9200-6Qs Line Card; Figure 25: Ex9200-4Qs Line Card; Switches - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide

Line Card Components

Related
Documentation

EX9200-6QS Line Card

60

Figure 25: EX9200-4QS Line Card

1— Ejector lever
2— Line card LED
3—MIC LED
You can use the show version
switches loaded on the switch.
The EX9200-4QS line card has:
Four 40-Gigabit Ethernet ports, each of which can house QSFP+ transceivers.
Four dust covers preinstalled in the ports.
Line card LED—An LED labeled
See "Line Card LED in an EX9200 Switch" on page
MIC LED—An LED labeled
See "Modular Interface Card LED in an EX9200 Switch" on page
LEDs for the ports—One LED on each port, the Link/Activity LED, which indicates the
link status and activity on the port. See
Switch" on page 37.
Line Card Model and Version Compatibility in an EX9200 Switch on page 55
Pluggable Transceivers Supported on EX9200 Switches on page 105
Installing a Line Card in an EX9200 Switch on page 220
Handling and Storing Line Cards in EX9200 Switches on page 215
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that you
can install in the line card slots on the front of the switch chassis. Line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
4— LEDs for the ports
5— 40-Gigabit Ethernet ports
command to see the version of Junos OS for EX Series
, which indicates the status of the line card.
OK/FAIL
75.
on each MIC, which indicates the status of the MIC.
OK/FAIL
"Network Port LEDs on Line Cards in an EX9200
38.
Copyright © 2017, Juniper Networks, Inc.