Related
Documentation
EX9200-40F Line Card
Line Card Models
Copyright © 2017, Juniper Networks, Inc.
Line Card Model and Version Compatibility in an EX9200 Switch on page 55
Pluggable Transceivers Supported on EX9200 Switches on page 105
Installing a Line Card in an EX9200 Switch on page 220
Handling and Storing Line Cards in EX9200 Switches on page 215
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that you can
install in the line card slots on the front of the switch chassis. Line cards are hot-insertable
and hot-removable: You can remove and replace them without powering off the switch
or disrupting switch functions.
This topic describes:
Line Card Models on page 71
Line Card Components on page 72
Table 32 on page 71
shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
Table 32: EX9200-40F Line Card
Model
Description
EX9200-40F
A line card with 40 1-Gigabit
Ethernet ports, each of which can
house 1-gigabit small form-factor
pluggable (SFP) transceivers
See
Figure 34 on page
71.
Figure 34: EX9200-40F Line Card
1—
Ejector lever
2—
Line card LED
3—MIC LED
You can use the
show version
switches loaded on the switch.
4—
LEDs for the ports
5—
1-Gigabit Ethernet ports
command to see the version of Junos OS for EX Series
Chapter 5: Line Cards
Junos OS Release Required
12.3R2 or later
71