CHAPTER 20
Maintaining and Replacing Line Card
Handling and Storing Line Cards in EX9200 Switches
Copyright © 2017, Juniper Networks, Inc.
Handling and Storing Line Cards in EX9200 Switches on page 215
Maintaining Line Card Cables in EX9200 Switches on page 218
Unpacking a Line Card Used in an EX9200 Switch on page 219
Installing a Line Card in an EX9200 Switch on page 220
Removing a Line Card from an EX9200 Switch on page 222
Components in the line cards are fragile. To avoid damaging the line cards, follow the
procedures in this topic. The procedures use the following terms to describe the four
edges of the line cards (see
Figure 71: Edges of the Line Cards
Faceplate—Edge of the line card that has connectors into which you insert the
transceivers or RJ-45 cables.
Connector edge—Edge opposite the faceplate.
Top edge—Edge at the top of the line card when the line card is vertical.
Bottom edge—Edge at the bottom of the line card when the line card is vertical.
CAUTION:
Failure to handle line cards as specified in these procedures can
cause irreparable damage to them.
Figure 71 on page
215):
215