Maintaining And Replacing Fiber-Optic Cable; Connecting A Fiber-Optic Cable - Juniper EX9214 Hardware Manual

CHAPTER 24
Maintaining and Replacing Fiber-Optic
Cable

Connecting a Fiber-Optic Cable

Copyright © 2017, Juniper Networks, Inc.
Connecting a Fiber-Optic Cable on page 243
Disconnecting a Fiber-Optic Cable from a Device on page 244
Maintaining Fiber-Optic Cables on page 245
Before you begin connecting a fiber-optic cable to an optical transceiver installed in a
device, ensure that you have taken the necessary precautions for safe handling of lasers
(see "Laser and LED Safety Guidelines and Warnings" on page
To connect a fiber-optic cable to an optical transceiver installed in a device:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
318).
Figure 58 on page 170).
243