Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Place one hand underneath the SF module to support it, and slide it completely out
6.
of the chassis. Place it on the antistatic mat.
CAUTION:
Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
If you are not replacing the SF module, install a cover panel over the empty slot.
7.
Figure 70 on page 213
shows removing an SF module from an EX9208 switch. The
procedure is the same for all EX9200 switches.
Figure 70: Removing an SF Module from an EX9200 Switch
SF
Ejectors
Installing an SF Module in an EX9200 Switch on page 209
Switch Fabric Module in an EX9200 Switch on page 33
Routing Engine Module in an EX9200 Switch on page 29
Chapter 19: Upgrading and Replacing Switch Fabric (SF) Module
213