Figure 14: Ex9200-Re Module In An Ex9200 Switch - Juniper EX9214 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Figure 14 on page 31 shows the EX9200-RE module in an EX9200 switch.

Figure 14: EX9200-RE Module in an EX9200 Switch

Auxiliary Ethernet
port port
Extractor
clip
Console USB Reset
port port button
Each EX9200-RE module consists of the following components:
Extractor clips—Control the locking system to securely install and remove the
EX9200-RE module.
port—Connects the EX9200-RE module to a modem or other auxiliary device.
AUX
port—Connects the EX9200-RE module to a system console through a
CONSOLE
cable with an RJ-45 connector. See
Console or an Auxiliary Device" on page
ETHERNET port—Connects the EX9200-RE module through an Ethernet connection
to a management LAN (or any other device that plugs into an Ethernet connection)
for out-of-band management. See
Out-of-Band Management" on page
port—Hosts a removable media interface through which you can install the Junos
USB
OS manually. See "USB Port Specifications for an EX Series Switch" on page
and
SATA SSD 1 SATA SSD 2
configuration files, and microcode. Also provide secondary storage for log files and
memory dump files.
RESET button—Reboots the EX9200-RE module when pressed.
button—Turns the EX9200-RE module online or offline when pressed.
ONLINE/OFFLINE
Status LEDs—Indicate the status of the EX9200-RE module. Each EX9200-RE module
has four LEDs labeled MASTER
Captive screws—Secure the EX9200-RE module in place.
Figure 15 on page 32 shows the EX9200-RE2 module in an EX9200 switch.
Chapter 2: Chassis Components and Descriptions
SSD OK/Fail SSD
slot 1 LED slot 2
Online Master Storage
LED LED LED
Extractor
clip
"Connecting an EX9200 Switch to a Management
166.
"Connecting an EX9200 Switch to a Network for
165.
slots—Host primary storage for software images,
, STORAGE , ONLINE , and
126.
OK/FAIL on the faceplate.
31