Figure 77: Installing The Septum; Figure 78: Removing The Septum - Juniper EX9214 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.

Figure 77: Installing the Septum

If you are installing an EX9200-40T-MIC and if there is a septum installed in the line
4.
card, remove the septum (see
Remove the screws labeled
a.
Remove the two screws labeled
b.
Slide the septum out of the line card.
c.
Save the septum and screws for later use.
d.

Figure 78: Removing the Septum

Remove four screws
on bottom.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Chapter 21: Replacing a MIC in an EX9200-MPC Line Card
Figure 78 on page 227):
on the bottom surface of the line card.
S
on the top surface of the line card.
S
Remove two
screws on top.
Slide septum
out.
227