Installing a Routing Engine into an EX9200-SF2
Powering On the Switch
Copyright © 2017, Juniper Networks, Inc.
To install a Routing Engine into an EX9200-SF2:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Ensure that the ejector handles are not in the locked position. If necessary, flip the
2.
ejector handles outward.
Place one hand underneath the Routing Engine to support it.
3.
Carefully align the sides of the Routing Engine with the guides inside the opening on
4.
the SF2.
Slide the Routing Engine into the EX9200-SF2 until you feel resistance, and then press
5.
the faceplate of the Routing Engine until it engages the connectors.
Press both of the ejector handles inward to seat the Routing Engine.
6.
Tighten the captive screws on the top and bottom of the Routing Engine.
7.
Connect the management device cables to the Routing Engine.
8.
See
"Powering On an AC-Powered EX9200 Switch" on page 156
DC-Powered EX9200 Switch" on page
Chapter 19: Upgrading and Replacing Switch Fabric (SF) Module
162.
or
"Powering On a
207