Figure 66: Removing A Dc Power Supply From An Ex9214 Switch - Juniper EX9214 Hardware Manual

Hide thumbs Also See for EX9214:

Table of Contents

EX9214 Switch Hardware Guide

Documentation

Figure 66: Removing a DC Power Supply from an EX9214 Switch

Let go of the locking pin in the release lever. Ensure that it is seated in the corresponding

hole in the chassis.

Do not touch the connector on the top of the power supply.

Pull the power supply straight out of the chassis.

Installing a DC Power Supply in an EX9214 Switch on page 193

DC Power Supply in an EX9214 Switch on page 49