Ex9200-40Xs Line Card; Line Card Models; Table 34: Ex9200-40Xs Line Card - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation

EX9200-40XS Line Card

Line Card Models

74
Line Card Model and Version Compatibility in an EX9200 Switch on page 55
Pluggable Transceivers Supported on EX9200 Switches on page 105
Installing a Line Card in an EX9200 Switch on page 220
Handling and Storing Line Cards in EX9200 Switches on page 215
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that you
can install in the line card slots on the front of the switch chassis. Line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
This topic describes:
Line Card Models on page 74
Line Card Components on page 75
Table 34 on page 74 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.

Table 34: EX9200-40XS Line Card

Model Description
EX9200-40XS A line card with 40 10-Gigabit Ethernet ports with
Media Access Control Security (MACsec)
capability, each of which can house 10-gigabit
small form-factor pluggable plus (SFP+)
transceivers. The EX9200-40XS line card
supports 802.1AE IEEE MAC Security standard
(also known as MACsec) with AES-128 bit
encryption, providing support for link-layer data
confidentiality, data integrity, and data origin
authentication. You must apply a single
license—EX9200-SFL—to enable MACsec.
NOTE: For the EX9200-40XS line card to be operational, you must install the EX9200-SF2 Switch
Fabric module (SF module) in the switch. See
page 33 and "Installing an SF Module in an EX9200 Switch" on page
Figure 36 on page 75 shows the components of an EX9200-40XS line card.
Junos OS Release
Required
16.1R1 or later
"Switch Fabric Module in an EX9200 Switch" on
209.
Copyright © 2017, Juniper Networks, Inc.