Removing An Re Module From An Ex9200 Switch; Figure 67: Installing An Re Module In An Ex9200 Switch - Juniper EX9214 Hardware Manual

Related
Documentation

Removing an RE Module from an EX9200 Switch

Copyright © 2017, Juniper Networks, Inc.

Figure 67: Installing an RE Module in an EX9200 Switch

RE
module
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Removing an RE Module from an EX9200 Switch on page 201
Switch Fabric Module in an EX9200 Switch on page 33
Routing Engine Module in an EX9200 Switch on page 29
CAUTION: Do not lift the Routing Engine module (RE module) by holding the
ejector levers. The levers cannot support the weight of the module. Lifting
the module by the levers might bend the levers. Bent levers will prevent the
RE module from being properly seated in the chassis.
Before you begin to remove an RE module:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
"Prevention of Electrostatic Discharge Damage" on page
Remove all the cables connected to the RE module.
CAUTION: Before you remove an RE module, you must take the host
subsystem offline. If there is only one RE module installed in the switch, taking
the host subsystem offline shuts down the switch.
Chapter 18: Replacing Routing Engine (RE) Module
329.
. Failure
201