Removing A Transceiver; Figure 83: Installing A Transceiver - Juniper EX9214 Hardware Manual

Related
Documentation

Removing a Transceiver

Copyright © 2017, Juniper Networks, Inc.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.

Figure 83: Installing a Transceiver

1— Ejector lever
Removing a Transceiver on page 237
Connecting a Fiber-Optic Cable on page 169
The transceivers for Juniper Networks devices are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the device or disrupting device functions.
NOTE: After you remove a transceiver or when you change the media-type
configuration, wait for 6 seconds for the interface to display the operational
commands.
Before you begin removing a transceiver from a device, ensure that you have taken the
necessary precautions for safe handling of lasers (see
and Warnings" on page 318).
Ensure that you have the following parts and tools available:
An antistatic bag or an antistatic mat
Rubber safety caps to cover the transceiver and fiber-optic cable connector
A dust cover to cover the port
Figure 84 on page 239 shows how to remove a QSFP+ transceiver. The procedure is the
same for all types of transceivers except the CFP transceivers.
Chapter 22: Replacing Transceiver
"Laser and LED Safety Guidelines
237