Figure 53: Ethernet Management Port On The Re Module In Ex9200 Switches; Figure 54: Ethernet Cable Connector - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation
Connecting an EX9200 Switch to a Management Console or an Auxiliary Device
166
Figure 53: Ethernet Management Port on the RE Module in EX9200
Switches
Auxiliary Ethernet
port port
Extractor
clip
Console USB Reset
port port button
Connecting an EX9200 Switch to a Management Console or an Auxiliary Device on
page 166
RJ-45 Management Port Connector Pinout Information on page 127
Management Cable Specifications on page 122
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate Console ( CONSOLE
use a laptop, modem, or other auxiliary device, connect it to the auxiliary (
the RE. Both ports accept a cable with an RJ-45 connector. One serial cable with an RJ-45
connector and a DB-9 connector is provided with the switch. To connect a device to the
port and another device to the
CONSOLE
Ensure that you have an Ethernet cable with an RJ-45 connector available. An RJ-45
cable and an RJ-45 to DB-9 serial port adapter are supplied with the device.
Figure 54 on page 166 shows the RJ-45 connector of the Ethernet cable supplied with the
switch.

Figure 54: Ethernet Cable Connector

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the device, use a combination
of the RJ-45 to DB-9 female adapter supplied with the device and a USB to
DB-9 male adapter. You must provide the USB to DB-9 male adapter.
To connect the device to a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
SSD OK/Fail SSD
slot 1 LED slot 2
Online Master Storage
LED LED LED
Extractor
clip
) port on the Routing Engine module (RE module). To
port, you must supply an additional cable.
AUX
) port on
AUX
Copyright © 2017, Juniper Networks, Inc.