Pluggable Transceivers Supported On Ex Series Switches - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation

Pluggable Transceivers Supported on EX Series Switches

106
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
The Gigabit Ethernet SFP, SFP+, and QSFP+ transceivers and the 100GBASE-LR4 CFP
transceivers installed in EX9200 switches support digital optical monitoring (DOM): You
can view the diagnostic details for these transceivers by issuing the operational mode
CLI command
show interfaces diagnostics optics
Installing a Transceiver on page 235
Removing a Transceiver on page 237
EX9200-2C-8XS Line Card on page 57
EX9200-4QS Line Card on page 59
EX9200-6QS Line Card on page 60
EX9200-MPC Line Card on page 62
EX9200-12QS Line Card on page 66
EX9200-32XS Line Card on page 68
EX9200-40T Line Card on page 69
EX9200-40F Line Card on page 71
EX9200-40F-M Line Card on page 72
EX9200-40XS Line Card on page 74
The transceivers for EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
NOTE: After you insert a transceiver or after you change the media-type
configuration, wait for 6 seconds for the interface to display the operational
commands.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
.
Copyright © 2017, Juniper Networks, Inc.