Connector Pinouts For An Mx Series Cb-Re Or Rcb Management Port - Juniper MX204 Hardware Manual

Table 24: RJ-45 Connector Pinout for the AUX and CONSOLE Ports (continued)
Pin Signal
7 DSR/DCD
8 CTS
RJ-45 Connector Pinouts for an MX Series CB-RE or RCB Management
Port
The port on the Control Board and Routing Engine (CB-RE; Routing and Control Board (RCB)) labeled
MGMT is an autosensing 10/100/1000-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable
for connecting the Routing Engine to a management LAN (or other device that supports out-of-band
management).
NOTE: In routers where the Routing Engine and Control Board (CB) are integrated into a single
board, a CB-RE is known as Routing and Control Board (RCB). The RCB is a single FRU that provides
Routing Engine and CB functionality.
Table 25 on page 69 describes the RJ-45 connector pinout.
Table 25: RJ-45 Management Port Connector Pinouts for the CB-RE or RCB MGMT Port
Pin
1
2
3
4
5
6
7
Description
Data Set Ready
Clear to Send
Signal
TRP1+
TRP1–
TRP2+
TRP3+
TRP3–
TRP2–
TRP4+
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
69