Battery Current Leakage Inspection; Regulated Voltage Inspection - Suzuki GSX1300R Manual

Suzuki gsx1300r motorcycle
Hide thumbs Also See for GSX1300R:
Table of Contents

Advertisement

Battery Current Leakage Inspection

Inspect the battery current leakage in the following
procedures:
1) Turn the ignition switch OFF.
2) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-14)".
3) Disconnect the battery (–) lead wire.
4) Measure the current between battery (–) terminal
and the battery (–) lead wire using the multi-circuit
tester. If the reading exceeds the specified value,
leakage is evident.
CAUTION
!
• In case of a large current leak, turn the
tester to high range first to avoid tester
damage.
• Do not turn the ignition switch ON when
measuring current.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Current (
, 20 mA)
Battery current (Leak)
Under 3 mA
5) Connect the battery (–) terminal and install the seat.
Refer to "Battery Removal and Installation (Page 1J-
14)" and "Exterior Parts Removal and Installation in
Section 9D (Page 9D-14)".

Regulated Voltage Inspection

B815H21A06002
Inspect the regulated voltage in the following
procedures:
1) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-14)".
2) Start the engine and keep it running at 5 000 r/min
with the dimmer switch turned HI position.
3) Measure the DC voltage between the battery (+) and
(–) terminals using the multi-circuit tester. If the
voltage is not within the specified value, inspect the
generator and regulator/rectifier. Refer to "Generator
Inspection (Page 1J-5)" and "Regulator / Rectifier
Inspection (Page 1J-10)".
NOTE
When making this test, be sure that the
battery is in fully charged condition.
Special tool
Tester knob indication
Voltage (
Regulated voltage (Charging output)
Standard: 13.5 – 15.5 V at 5 000 r/min
4) Install the seat. Refer to "Exterior Parts Removal and
Installation in Section 9D (Page 9D-14)".
I649G11A0002-02
Charging System:
(A): 09900–25008 (Multi-circuit tester set)
)
Battery
(DCV)
Tester
1J-4
B815H21A06003
I649G11A0003-02

Advertisement

Table of Contents
loading

Table of Contents