Remote-Span - Cisco Sx350 Cli Manual

SPAN and RSPAN Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
switchxxxxxx(config)#
gi11
Example 3. The following example configures a final RSPAN session that copies
traffic from a RSPAN VLAN 2 to destination port
switchxxxxxx(config)#
switchxxxxxx(config-vlan)#
switchxxxxxx(config-vlan)#
switchxxxxxx(config)#
switchxxxxxx(config)#

57.3 remote-span

To configure a virtual local area network (VLAN) as a RSPAN remote VLAN, use the
remote-span command in VLAN Configuration mode. To return to default, use the
no form of this command.
Syntax
remote-span
no remote-span
Parameters
This command has no arguments or keywords.
Default Configuration
A VLAN is not a RSPAN remote VLAN.
Command Mode
VLAN Configuration mode
monitor session 1 destination remote vlan 2 reflector-port
vlan 2
remote-span
exit
monitor session 1 source remote vlan 2
monitor session 1 destination interface gi11
1:
gi1
57
1094