Show Ipv6 Access-List - Cisco Catalyst 3560-X Command Reference Manual

show ipv6 access-list

show ipv6 access-list
Syntax Description
Command Modes
Command History
Usage Guidelines
Examples
Catalyst 3750-X and 3560-X Switch Command Reference
2-636
Downloaded from www.Manualslib.com
Use the show ipv6 access-list user EXEC command to display the contents of all current IPv6 access
lists.
show ipv6 access-list [access-list-name]
access-list-name
User EXEC
Release Modification
12.2(53)SE2 This command was introduced.
The show ipv6 access-list command provides output similar to the show ip access-list command, except
that it is IPv6-specific.
To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
The following output from the show ipv6 access-list command shows IPv6 access lists named inbound
and outbound:
Switch# show ipv6 access-list
IPv6 access list inbound
permit tcp any any eq bgp (8 matches) sequence 10
permit tcp any any eq telnet (15 matches) sequence 20
permit udp any any sequence 30
Table 2-37 describes the significant fields shown in the display.
Table 2-37 show ipv6 access-list Field Descriptions
Field
IPv6 access list inbound
permit
tcp
any
eq
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
(Optional) Name of access list.
Description
Name of the IPv6 access list, for example, inbound.
Permits any packet that matches the specified protocol type.
Transmission Control Protocol. The higher-level (Layer 4) protocol type
that the packet must match.
Equal to ::/0.
An equal operand that compares the source or destination ports of TCP or
UDP packets.
OL-21522-02