Show Ipv6 Access-Lists - Cisco Nexus 5500 Series Command Reference Manual

Chapter Show Commands

show ipv6 access-lists

To display all IPv6 access control lists (ACLs) or a specific IPv6 ACL, use the show ipv6 access-lists
command.
Syntax Description access-list-name
expanded
summary
Command Default None
Command Modes
EXEC mode
Command History Release
5.2(1)N1(1)
Usage Guidelines The device shows all IPv6 ACLs, unless you use the access-list-name argument to specify an ACL.
The summary keyword allows you to display information about the ACL rather than the ACL
configuration. The information displayed includes the following:
•
•
•
•
The show ipv6 access-lists command displays statistics for each entry in an ACL if the following
conditions are both true:
•
•
Examples
This example shows how to display all IPv6 ACLs on a switch:
switch# show ipv6 access-lists
OL-27883-02
show ipv6 access-lists [access-list-name] [expanded | summary]
(Optional) Name of an IPv6 ACL, which can be up to 64 alphanumeric,
case-sensitive characters.
(Optional) Specifies that the contents of IPv6 address groups or port groups
show rather than the names of object groups only.
(Optional) Specifies that the command displays information about the ACL
rather than the ACL configuration. For more information, see the "Usage
Guidelines" section.
Modification
This command was introduced.
Whether per-entry statistics is configured for the ACL.
The number of rules in the ACL configuration. This number does not reflect how many entries the
ACL contains when the device applies it to an interface. If a rule in the ACL uses an object group,
the number of entries in the ACL when it is applied may be much greater than the number of rules.
The interfaces that the ACL is applied to.
The interfaces that the ACL is active on.
The ACL configuration contains the statistics per-entry command.
The ACL is applied to an interface that is administratively up.
Cisco Nexus 5500 Series NX-OS Security Command Reference
show ipv6 access-lists
293