Verifying The Policy Map Configuration - Cisco Nexus 5000 NX-OS Service Configuration Manual

Verifying the Policy Map Configuration

Step 3
Step 4
Step 5
Step 6
Step 7
Verifying the Policy Map Configuration
Command
show policy-map [name]
show policy-map interface [interface number]
show policy-map system
show policy-map type {network-qos | qos |
queuing} [name]
running-config ipqos
Cisco Nexus 5000 NX-OS Quality of Service Configuration Guide, Release 5.1(3)N2(1)
24
Command or Action
switch(config-pmap-que)# class
type queuing class-name
switch(config-pmap-c-que)#
priority
switch(config-pmap-c-que)# no
priority
switch(config-pmap-c-que)#
bandwidth percent percentage
switch(config-pmap-c-que)# no
bandwidth percent percentage
Purpose
names can contain alphabetic, hyphen, or underscore
characters, are case sensitive, and can be up to 40
characters.
Associates a class map with the policy map, and enters
configuration mode for the specified system class.
Specifies that traffic in this class is mapped to a strict
priority queue.
Only one class in each policy map can have strict
Note
priority set on it.
(Optional)
Removes the strict priority queuing from the traffic in this
class.
Specifies the guaranteed percentage of interface bandwidth
allocated to this class. By default, no bandwidth is specified
for a class.
Before you can successfully allocate bandwidth
Note
to the class, you must first reduce the default
bandwidth configuration on class-default and
class-fcoe.
(Optional)
Removes the bandwidth specification from this class.
Purpose
Displays the policy maps defined on the switch.
Optionally, you can display the named policy only.
Displays the policy map settings for an interface or
all interfaces.
Displays the policy map settings attached to the
system qos.
Displays the policy map settings for a specific policy
type. Optionally, you can display the named policy
only.
Displays information about the running configuration
for QoS.
Configuring Policy Maps
OL-26657-01