Figure 84: Installing A Cip - Juniper T640 Hardware Manual

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Carefully push the CIP straight into the chassis until it contacts the midplane.
4.
Tighten the screws at the top and bottom of the CIP faceplate.
5.
Reattach any external devices connected to the CIP.
6.
CAUTION: Be sure to slide the CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
To verify that the CIP is installed correctly, plug an Ethernet cable into the Ethernet
7.
port on the CIP. If the host module is operational, the
Ethernet activity. If you can run the CLI, the CIP is installed correctly.

Figure 84: Installing a CIP

T640 Preventing Electrostatic Discharge Damage on page 306
T640 Routing Engine Ports on page 47
Connecting the T640 Router to a Management Console or Auxiliary Device on page 119
Chapter 17: Replacing T640 Router Hardware Components
ACTIVE LED blinks to indicate
179