Replacing The M320 Connections To Routing Engine Interface Ports; Figure 65: Installing A Cip - Juniper M320 Hardware Manual

M320 Router Hardware Guide

Figure 65: Installing a CIP

Replacing the M320 Connections to Routing Engine Interface Ports

142
Tighten the screws at the top and bottom of the CIP faceplate.
5.
Reattach any external devices connected to the CIP.
6.
CAUTION: Be sure to slide the CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
To verify that the CIP is installed correctly, plug an Ethernet cable into the Ethernet
7.
port on the CIP. If the host module is operational, the
Ethernet activity. If you can run the CLI, the CIP is installed correctly.
The ports on the CIP connect the Routing Engine to external management devices (see
Figure 66 on page 143).
LED blinks to indicate
ACTIVE
Copyright © 2010, Juniper Networks, Inc.