ACX5048 and ACX5096 Universal Access Router
Two Post Procedure
108
Figure 33: Slide Mounting Blades into 1 U Mounting Rail
1—
Rearmounting-blades
2—Side mounting-rails
Ensure that the router chassis is level by verifying that all the screws on the front of
9.
the rack are aligned with the screws at the back of the rack.
You can center mount a ACX5096 on two posts of a 19-in. rack or cabinet by using the
short mounting brackets provided with the router. Other product SKUs of the ACX5000
are not recommended for two post installation.
To mount the router on two posts in a rack using the provided mounting kit:
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
1.
Decide whether the Field Replaceable Unit (FRU) end of the router or the port end is
2.
to be placed at the front of the rack. Position the router in such a manner that the
labels on components are next to the hot aisle.
OUT
Align the tenmounting holes on the short mounting bracket with one of the three sets
3.
of corresponding holes along the side of the router chassis . See
Figure 34: Attaching a Two-Post Mounting Bracket to ACX5096 Router
Attach the mounting bracket to the ACX5096 using eight mounting screws (and cage
4.
nuts and washers if your rack requires them).
3—
Router chassis
Figure 34 on page
Copyright © 2015, Juniper Networks, Inc.
AIR
108.