Main Parts - Intermec EasyCoder 501 XP Service Manual

9.2 Main Parts

Belt to
Liner Drive Roller
Tension Roller
Intermec EasyCoder 501 XP & 601 XP – Service Manual
The stepper motor is fi tted to the printer's center section using a
motor support plate. It drives the liner/batch takeup unit and the
liner drive roller in the print unit via two belts. The tension of these
belts can be slightly adjusted by moving the stepper motor and/or
support plate before the screws are tightened.
The takeup unit is fi tted with a brace, that holds the liner or media.
The unit is fi tted to the printer's center section by means of two
#T20 Torx screws that can be accessed through holes in the CPU
board (switch off the power fi rst!)
A break shaft in front of the takeup unit guides the liner or media
under the slack absorber.
The stepper motor is connected to P421 on the CPU board, see
Chapter 15.3.
EasyCoder 501 XP
Stepper Motor
Motor Support Plate
Belt to Liner/Batch Takeup Unit
Liner/Batch Takeup Unit
Chapter 9 Liner/Batch Takeup Kit
Break Shaft
Brace
91