Intermec EasyCoder 601XP Reference Manual

Easyset bar code wand

Hide thumbs Also See for EasyCoder 601XP:

Table of Contents

Download this manual See also: Service Manual, User Manual

Intermec EasyCoder 501 XP/601 XP

EasySet Bar Code Wand Setup

1. Connect the EasySet bar code wand to the

receptacle on the printer's rear plate.

3. When the bar code has been accepted, the prin-

ter emits a short beep and the Ready control

lamp on the printer's front blinks briefly.

Baudrate

1-960438-02 EasySet Bar Code Sheet for EasyCoder 501 XP/601 XP, Edition 3, September 1998

2. Read the appropriate bar code to set up the prin-

ter. Hold the wand like a pencil and move it

rather swiftly across the bar code.

Connect here!

4. This sheet only contains a selection of setup

options. For information on how to produce your

own setup bar codes, please refer to the Inter-

mec Fingerprint 7.12 Reference Manual.

Table of Contents

Do you have a question about the EasyCoder 601XP and is the answer not in the manual?

Page 1 Intermec EasyCoder 501 XP/601 XP EasySet Bar Code Wand Setup 1. Connect the EasySet bar code wand to the receptacle on the printer’s rear plate. 3. When the bar code has been accepted, the prin- ter emits a short beep and the Ready control lamp on the printer’s front blinks briefly.
Page 2 Serial Communication on ”uart1:”, cont’d. Char. Length Parity No. of Stop Bits Reset comm. to default RTS/CTS ENQ/ACK XON/XOFF, Data to Host...
Page 3 Serial Communication on ”uart1:”, cont’d. XON/XOFF, Data from Host New Line Start- and Stopadjust Tear Off Peel Off Cut Off Media Contrast...
Page 4 Media, cont’d. Media Width Media Length...
Page 5 Media, cont’d. Media Length, cont’d. Media Type Print Speed Test Labels...
Page 6: Paper Type
Paper Type Direct Thermal Printing (Europe) Direct Thermal Printing (USA)
Page 7 Paper Type, cont’d. Thermal Transfer Printing (Europe)
Page 8 Paper Type, cont’d. Thermal Transfer Printing (USA)

Easycoder 501xp