Main Parts - Intermec EasyCoder PX4i Service Manual

9.2 Main Parts

EasyCoder PX4i
Belt to
liner drive roller
Tension roller
EasyCoder PX4i and PX6i Service Manual
Downloaded from www.Manualslib.com
The stepper motor is fi tted to the printer's center section using a motor
support plate. It drives the liner/batch takeup unit and the liner drive roller
in the print unit via two belts. The tension of these belts can be slightly
adjusted by moving the stepper motor and/or support plate before the
screws are tightened.
The takeup unit is fi tted with a brace, that holds the liner or media. The
unit is fi tted to the printer's center section using two #T20 Torx screws
inserted from media compartment.
A break shaft in front of the takeup unit guides the liner or media under
the slack absorber.
The stepper motor is connected to P11 on the driver board, see Chapter
14.
Stepper motor
Motor support plate
Liner/batch takeup unit
manuals search engine
Belt to liner/batch takeup unit
Break shaft
Chapter 9 — Liner Takeup Kit
Brace
109