Adjustments - Intermec EasyCoder 501 XP Service Manual

Chapter 10 Label Taken Sensor

10.3 Adjustments

98
Adjust the sensitivity of the label taken sensor by means of the
potentiometer WR51 (marked "LTS") on the CPU board:
• Start up Intermec Fingerprint and run the program described
in Chapter 10.2. Leave the label in the outfeed slot to create a
label-not-taken condition.
• The printer should start to beep continuously. If not, turn the
potentiometer back and forth until the beeping starts.
• Adjust the potentiometer WR51 so the beeping does not stop
when the screw is turned a quarter of a turn in either direction.
• If necessary, fi t or remove a jumper on P55 to change the inten-
sity of the LTS emitter:
Jumper fi tted
Jumper removed
• Remove the label. The beeping should cease immediately.
• If necessary, readjust the potentiometer and/or change the strap
on P55.
• Break the program by typing X on the host.
When the label taken sensor works properly, put back the left-
hand cover and close the front hatch and right-hand door. Then the
printer is ready for operation.
Intermec EasyCoder 501 XP & 601 XP – Service Manual
= Higher intensity
= Lower intensity