Fuji Xerox ApeosPort-II C4300 User Manual page 523

Category
Error Code
C P F S M O
116-748
O
116-749
O
116-752
O
116-771 O
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-780
116-790
O
123-400 O
124-701
124-702
124-704
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
[Cause] There is no plot data in the HP-GL/2 print data.
[Remedy] Check the print data.
[Cause] The job was cancelled because the specified font does not
exist.
[Remedy] Install the font, or set the font replacement on the print
driver.
[Cause] The descriptions of the PDF printing job ticket has a
problem.
[Remedy] Try again. If the problem persists, contact our Customer
Support Center.
[Cause] The data was automatically modified because it included
an invalid parameter.
[Remedy] The printed image may be incomplete. Check if the image
has no problem, or ask the sender to send the data again.
When using the iFax forwarding feature, check the data
sent to the e-mail recipient.
O O [Cause] There is a problem with the document attached to the
received e-mail.
[Remedy] Check the attached document.
[Cause] 1. If the operator cancelled printing a document that was
received using the Fax to Mailbox or iFax to Mailbox
feature:
The first set of the document is not stapled.
2. For a cause other than Cause 1:
All the sets of the document are not stapled.
[Remedy] For Cause 1. Manually staple the first set of the document.
Or, do not cancel printing a document that is received
using the Fax to Mailbox or iFax to Mailbox feature.
For Cause 2. Check if the staple position has been
correctly specified, and try printing again.
[Cause] Machine malfunction
[Remedy] Turn the machine off and on. If the problem persists,
contact our Customer Support Center.
O [Cause] The output destination was changed to the center tray due
to the malfunction of the specified side tray.
[Remedy] Contact our Customer Support Center. Any trays other
than the defective output tray can be used.
O [Cause] The output destination was changed to the center tray due
to the malfunction of the specified Finisher tray.
[Remedy] Contact our Customer Support Center. Any trays other
than the defective output tray can be used.
O [Cause] The output destination was changed to the center tray due
to the malfunction of the specified output tray.
[Remedy] Contact our Customer Support Center. Any trays other
than the defective output tray can be used.
Cause and Remedy
Error Code
15
521