Machine Trouble - Fuji Xerox ApeosPort-II C4300 User Manual

15 Problem Solving

Machine Trouble

Before you determine that the machine is defective, check the machine status again.
The machine is
not powered on.
The touch screen
is too dark.
15
438
Symptom Cause
Is the <Reset> button or
power switch off on the
machine?
Is the power cord plugged
into the power outlet?
Is the power cord
disconnected from the
machine or the rear of the
rack?
Does the AC outlet supply
power properly?
Is the <Power Saver>
button on?
Is the screen contrast low?
Remedy
Turn the <Reset> button and power switch
on.
Refer to "Power On / Off" (P.35).
Turn the power switch off, and then firmly
plug the power cord into the connector and
power outlet. Then turn the power switch
on.
Refer to "Power On / Off" (P.35).
Connect another appliance to the outlet to
verify the power supply.
The machine is in the Power Saver mode.
Press the <Power Saver> button on the
control panel to exit the Power Saver
mode.
Refer to "Power Saver mode" (P.38).
Adjust the screen contrast by using the
contrast adjustment dial or the <Screen
Contrast> button on the control panel.
Refer to "Control Panel" (P.41).