Fuji Xerox ApeosPort-II C4300 User Manual page 335

Send as iFax
Specify an address for iFax transmission.
You can specify a total of up to 100 addresses, using either address numbers or direct input.
Important • It is not possible to use wildcard or group dial number specifications.
Address Number
Specify an address with an address number. Enter the address number with the numeric
keypad, and select [Save]. The specified address appears in [Recipient Name/E-mail
Address] on the [Send as iFax] screen.
New Recipient
Specify a new address. Select the item you want to change, and select [Change Settings].
The specified address appears in [Recipient Name/E-mail Address] on the [Send as iFax]
screen.
Delete Recipient
Deletes all information for the selected addresses.
Change Settings
Confirm or change the selected recipients.
For information about the method for confirm/change, refer to Address Book (Address Number)
(P.334).
Print
Make print settings. When [On] is selected, you then configure print settings.
Quantity
Set the number of copies from 1 to 999, in 1 copy increments.
Paper Supply
Select the printing paper tray. When [Auto Paper] is selected, the same paper size as the
original size is printed.
Note • When printing the fax document for Private Polling and Fax to Mailbox, if [Tray Mode] in
[Receive Paper Size] is selected, the document will be printed automatically on the paper
loaded on the bypass tray in case the specified paper tray cannot be used. For information
on [Receive Paper Size] settings, refer to Receiving Paper Size (P.317)
Auto Paper
A suitable paper tray is automatically selected.
Trays 1 to 4
Select paper from 4 trays.
Bypass
Prints on paper loaded in the Tray 5 (Bypass).
2 Sided Printing
Sets the 2-sided printing option.
Output
Perform the stapling, hole punching, and output destination settings.
Stapling
Set the position for stapling.
Hole Punching
Set the position for punching.
Output Destination
Select the output destination.
Edit/Delete
Check the content of a job flow sheet, and edit, copy, or delete it.
Setup Menu
10
333