Fuji Xerox ApeosPort-II C4300 User Manual page 524

15 Problem Solving
Error Code
C P F S M O
124-705
O
124-706
O
127-320
124-708
O
124-709 O
15
133-210
133-211
133-212
133-213
133-214
133-215
133-216
133-217
133-218
133-219
133-220
133-221
133-222
133-223
133-224
133-226
133-280
133-281
133-282
133-283
133-700 O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
522
Category
[Cause]
[Remedy] Check the punch position, and try again.
[Cause]
[Remedy] Check the folding setting, and try to print again.
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
[Cause]
[Remedy] For Cause 1. Check if the specified size paper has been
[Cause]
[Remedy] Reduce the number of pages, or cancel the stapling
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
[Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
[Cause]
[Remedy] Check the staple/punch positions, and try again.
Cause and Remedy
The punch setting was cancelled.
The folding setting was cancelled.
An error occurred with the machine.
not improved by performing the relevant remedy, contact
our Customer Support Center.
The output destination was changed to the center tray due
to the malfunction of the specified tray. Probable causes
are as follows:
1. The size of the paper used was different from the size
specified for the 2-Sided feature.
2. The punch unit on the C Finisher is defective.
loaded in a paper tray.
For Cause 2. If the control panel displays Error Code 012-
231, 012-232, 012-233, or 012-234, contact our Customer
Support Center.
The document exceeded the maximum number of pages
that can be stapled.
setting, then try to print again.
An error occurred during fax transmission.
not improved by performing the relevant remedy, contact
our Customer Support Center.
An unsupported country code was specified.
An error occurred during fax transmission.
not improved by performing the relevant remedy, contact
our Customer Support Center.
The staple/punch setting was cancelled.