Document Glass - Fuji Xerox ApeosPort-II C4300 User Manual

1
Remove any paper clips and
staples before loading the
document.
2
Place the document (the front side
of 2-sided document) face up in the
center of the document feeder.
Note • The indicator lights when the
3
Adjust the movable document
guides to just touch the edges of
the document loaded.

Document Glass

The document glass supports a single sheet, a book, or other similar documents up to
297 x 432 mm (A3, 11 x 17 inches).
Important • Close the document cover after the job is completed when the document glass is used.
The document feeder automatically detects standard size documents. For non-
standard size documents, input the size in the [Original Size] screen.
For information on entering document sizes, refer to "Original Size (Specifying the Scan Size for the
Document)" (P.72).
Note • The standard document sizes that can be detected automatically depend on the [Paper Size
1
Open the document cover.
Important • Check that the screen of the
2
Place the document face down,
and align it against the top left
corner of the document glass.
3
Close the document cover.
Note • When a standard size
document is loaded correctly.
If the indicator does not light
up, the document glass
detects the document. Press
the <C> button, and then
reload the document.
Settings] in the System Administration mode. For information on the paper size settings,
refer to "Paper Size Settings" (P.286).
control panel is displayed
correctly and then load the
document. When the
document is loaded before the
screen is displayed, the
machine may not properly
detect document sizes.
document is placed on the
document glass, the size of
the document is displayed in
the message area.
Copying Procedure
Indicator
3
49