Fuji Xerox ApeosPort-II C4300 User Manual page 468

15 Problem Solving
Error Code
C P F S M O
003-753
003-754
O
003-755
003-756
003-757
003-760
003-761
O O
003-763
15
003-780
003-795
O
003-970
003-972
O
003-973 O O
003-976
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
466
Category
O [Cause]
[Remedy] Set [Scan Resolution] to [200dpi] or lower, and try again.
O [Cause]
[Remedy] Execute the job again.
O [Cause]
[Remedy] Check whether or not the document is blank or the
O [Cause]
[Remedy] Set [Scan Resolution] to [300dpi] or lower, and try again.
O O [Cause]
[Remedy] Check the selected options.
[Cause]
[Remedy] Change the paper size for the tray, or change the [Paper
O [Cause]
[Remedy] Place the Adjustment Chart properly on the document
Refer to "Executing Calibration" (P.430).
O [Cause]
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to
[Cause]
[Remedy] Take one of the following actions:
O Refer to 003-976.
O O [Cause]
[Remedy] Have your System Administrator check the setting of
[Cause]
[Remedy] Press the <Start> button to proceed, or cancel the job to
O [Cause]
[Remedy] Change the document size, or split the document to send it
Cause and Remedy
The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
An error occurred in the document scanner.
The fax document is all blank.
document is correctly loaded.
The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
An incompatible combination of features are specified as
document scan conditions.
The paper size of the tray selected for auto tray is different
from the paper size of the tray selected for Auto Repeat.
Type Priority] settings.
An error occurred when reading the Calibration Chart.
glass.
Failed to compress the scanned document.
decrease the data size, or split the data to send it
separately.
When enlarging/reducing a scanned document to the
specified paper size, the reduction/enlargement ratio value
is out of allowed range.
Manually enter a reduction/enlargement ratio.
Change the paper size.
The document exceeded the maximum number of stored
pages.
[Maximum Stored Pages].
The document orientation is different from the orientation
of the specified paper.
change the orientation.
The document size is out of allowed range.
separately.