Fuji Xerox ApeosPort-II C4300 User Manual page 446

15 Problem Solving
The copy is
misaligned or
skewed.
Part of the image
is missing on the
copy.
15
The copy has a
stripe pattern.
Tonal
reproduction for
color copies is
poor, resulting in
unsatisfactory
image quality.
444
Symptom Cause
Is the document loaded
correctly?
Is the paper loaded correctly
in the tray?
Are the paper guides of the
Tray 5 (Bypass) correctly
aligned with the paper?
Are the document guides on
the document feeder in the
correct positions?
Is the paper tray inserted
correctly?
Is the paper damp?
Is folded or wrinkled paper
included in the tray?
Is the document pasted or
folded?
Is the enlargement ratio
large?
Is tonal reproduction poor?
Is the machine exposed to
direct sunlight?
Remedy
Load the document correctly.
Refer to "Step 1 Loading Documents" (P.48).
Load the paper correctly.
Refer to "Loading Paper in the Trays 1 to 4"
(P.249).
Load the paper correctly.
Refer to "Loading Paper in the Tray 5
(Bypass)" (P.250).
Load the document correctly, and align the
document guides with the document sides.
Refer to "Step 1 Loading Documents" (P.48).
Firmly push in the tray as far as possible to
insert it properly.
Refer to "Loading Paper in the Trays 1 to 4"
(P.249).
If the paper is damp, the copy image may
be partially missing or unclear. Replace the
paper with new one.
Refer to "Loading Paper" (P.249).
Remove the improper paper or replace
whole paper with new one.
Refer to "Loading Paper" (P.249).
There may be a gap between the
document glass and the pasted or folded
section. Place a stack of white sheets on
the document to remove the gap between
the document and the document glass.
Output may have vertical stripes
depending on the ratio. Adjust the ratio to
remove the stripes.
Refer to "Reduce/Enlarge (Making Enlarged/
Reduced Copies)" (P.56).
Perform calibration.
Refer to "Executing Calibration" (P.430).
If the machine is switched on or the Power
Saver mode is cancelled while the
document glass is exposed to strong light,
tonal reproduction may become poor. In
that case, close the document cover,
switch the machine on, wait until the
machine is ready to copy or print, and then
turn the machine off/on again.