File Destination/Output Destination - Fuji Xerox ApeosPort-II C4300 User Manual

10 System Settings
Edge Erase - Left & Right Edges
Specify an amount of border erased from the original in left and right directions. Specify a
value in the range from 0 to 20 mm, in 1 mm increments.
Reduce 8.5x11"
When [Reduce/Enlarge] in the [Layout Adjustment] screen is set to [Auto %], you can set
whether to reduce 8.5×11"
Pseudo-Photo Gradation Mode
You can set the toning method for photo originals. To get closer to photo image quality, select
the handling of intermediate tones (gray). You can select from [Error Diffusion] and [Dither].
Box Selector - Line Setup
Select whether to use the Box Selector - Line Setup feature.
The Box Selector - Line Setup feature allows you to classify received documents into line
types and store them in specified mailboxes.
Memory Full Procedure
When the space of the hard disk runs out during scanning originals, a screen appears asking
how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the subsequent
processing is determined by these settings.
You can set the time until the memory full procedure is carried out. For more information, refer to Auto
Job Release (P.273).
Cancel Job
The stored data is discarded.
Run Job
The read-in data is treated as valid, and the part of the original read in is treated as a
complete stored file.
Maximum Stored Pages
Specify the maximum number of stored pages of a fax original. You can set a number from 1
to 999 pages.
Mailbox Receive Display Priority 1 to 3
Set the priority to display the fax document information received using mailboxes. For
instance, when using Network Scanner Utility2, the fax information is displayed in the
[Recipient] section of the document list screen.
There are the priority levels from 1 - 5. All priority can be set, however, if you want to display
only one priority level, make the settings of all priority levels the same.
Note
10
Direct Fax
Set whether to allow the use of Direct Fax. When selecting [Disabled], Direct Fax feature
cannot be used.

File Destination/Output Destination

File Destination/Output Destination allow you to specify a method for classifying
received documents into specified mailboxes. This setting is used for the box selector
feature.
318
Original to A4
size to A4
• This feature is not available for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
, while scanning the original.