Auto Print - Fuji Xerox ApeosPort-II C4300 User Manual

1
Select [Time Zone], and select
[Change Settings].
2
Set the time difference from GMT.
Daylight Savings
With this feature enabled, the machine automatically adjusts the current time when
daylight savings time starts and ends. Specify the start and end dates of daylight
savings time periods.
1
Select [Daylight Savings], and
select [Change Settings].
2
Select [Adjust On].
3
Set the start date for daylight
savings time in [Start Date].
Set the end date for daylight
savings time in [End Date].
NTP Time Synchronization
You can obtain the time from a time server (NTP: Network Time Protocol), to synchronize the
machine time to the server time.
Connection to Time Server
Select whether to connect to a time server. If you select [Off], the machine does not obtain
the time from a time server.
Connection Interval
Select the time interval at which a connection is made to the time server.
Select an interval from 1 to 500 hours in 1 hour increments.
Time Server IP Address
Set the IP address of the time server from which the time is obtained, using values 0 to 255.
Note • The range between 244.XXX.XXX.XXX and 255.XXX.XXX.XXX, and 127.XXX.XXX.XXX
Auto Clear
If a given time period elapses with no operation, the machine automatically returns to the
initial screen.
When [On] is selected, specify a value between 30 and 240 seconds, in 1 second increments.
In order not to set this feature, select [Off].
Note • Even if [Off] is selected, when there is no operation for 1 minute on the screen waiting for a
Auto Job Release
If an error occurs (document or paper jams, running out of paper, etc.) during copying or
scanning, the machine cancels the active job and starts the next job after a given period of
time. In that case, jobs that can be activated are limited to those that only use parts of the
machine not affected by the error.
When [On] is selected, specify a value between 4 and 99 minutes, in 1 minute increments. In
order not to set this feature, select [Off].

Auto Print

Set the time period to start the next print job after finishing a copy operation.
cannot be set.
job command after scanning, the machine cancels the waiting condition and starts to
process the scanned documents.
Common Settings
10
273