Fns Adjustment Of The Three-Holding Position (Only For Fn-9) - Konica Minolta CF5001 Service Manual

CF5001 Field Service Ver.1.0 Sep 2003
9.18 FNS adjustment of the three-
holding position (only for
FN-9)
A. Procedure
1. Check whether "adjustment of the angle of the
folding stopper" has been completed.
Folding Standard value
position A4R
a 95 mm
b 101 mm
c 101 mm
2. Perform a three-folding operation to check
whether the three-folding position is within the
specification.
If it is not within the specification, perform the
following adjustment.
3. Turn on the main body, adjust the first folding
position (standard value a) in "Finisher adjust-
ment" ⇒ "Three-holding position adjustment" in
the 36 mode. Then, perform the three-folding for
confirmation.
4. Once the first folding line is adjusted within the
specification, open the finisher door and pull out
the stacker unit.
5. Open the three-folding guide plate [1], loosen 2
three-folding stopper screws [2], and then adjust
the position of the three-folding stopper [4]
based on the mark [3].
6. Tighten the 2 screws [2], then perform the three-
folding to check whether the three-folding posi-
tion is within the standard value.
Specification
8.5 x 11R
89.4 mm ± 2 mm
95 mm ± 2 mm
95 mm ± 2 mm
2-161
OTHER ADJUSTMENTS
c
a
b
[2]
[4]
8050fs1110
[3]
[1]
[2]
8050fs1111