Table of Contents
Advertisement
9. Set the pin [1] and the gear [2] to the shaft and
fasten it with the E-ring [3].
10. Using a tension gauge or spring balance, pull
the belt tensioner [1] to the specified force "A"
and tighten it with 2 screws [2].
Specified value: A = 2.5 ± 0.25 kg
11. Loosen 2 screws [2] of the wire bracket [1] on
the front side. Press down the up/down stay [3]
to make it level, and tighten screws [5] of the
wire bracket [4] on the rear side and screws (4
screws in all).
Note:
• Be sure to check if the up/down stay [3] is
level. If it is out of the level, an undesirable
load may be imposed on the tray up/down
motor (M703) or the gear, causing damage to
it.
12. Reinstall the above parts following the removal
steps in reverse.
[1]
[2]
[3]
[1]
[5]
[4]
1-174
FN-9/FN120 Ver.1.0 Sep 2003
fs2153028
[2]
fs2153029
[2]
[1]
[3]
fs2153030
Advertisement
Table of Contents
