Table of Contents
Advertisement
TRAY UP/DOWN
6. Insert the up/down wire /A [2] into the hole [1]
provided on the upper surface of the LCT main
body.
7. Reinstall the up/down wire /A [2] onto the guide
pulleys [3], [4] and [5] in this order.
Note:
• When reinstalling the up/down wire /A [2] onto
the guide pulleys [3], [4] and [5], be sure to
insert the wire into the pulley through the
notch [6] provided on the side of each pulley
and then move the wire cover [7] of each pul-
ley to the wire that has been already inserted.
When moving the wire cover [7], move it first
to the position where the notch [6] can be
avoided and then move the wire in the notch
[6] into each pulley.
8. Insert the up/down wire /A [2] into the wire
installation hole [9] provided at the middle of the
up/down drive shaft [8].
Note:
• The up/down drive shaft [8] is provided with 3
wire installation holes each on the front side
and the rear side. In this step, the wire instal-
lation hole at the middle is to be used. Since
the inner-most wire installation hole has been
already used, however, only two wire installa-
tion holes can be confirmed for this steps. As
a result, the one near to the drive pulley that
has been already installed is the wire installa-
tion hole [9] at the middle.
9. Insert the drive pulley [10] into the up/down pul-
ley shaft [8] so that the notch [11] of the drive
pulley [10] comes to the position into which the
up/down wire /A [2] is put.
10. Fit the E-ring [12] to fasten the drive pulley [10].
[1]
[4]
[3]
[5]
[7]
[2]
[6]
1-154
C-208 Ver.1.0 Sep 2003
[2]
[7]
[6]
[2]
[8]
[2]
[10]
[2]
[10] [11]
[9]
[8]
[12]
lt2113040
Advertisement
Table of Contents
