Table of Contents
Advertisement
CF5001 Field Service Ver.1.0 Sep 2003
5. After removing the stop ring [1], pull out the feed
shaft [2] and remove the paper feed gear
assembly [3].
6. Remove the paper feed roller [4] from the paper
feed gear assembly [3].
7. Remove the feed roller assembly [2] from the
by-pass drive shaft [1].
8. Remove the feed roller [3] from the feed roller
assembly [2].
Note:
• Be sure to install the feed roller [3] so that the
paint mark [4] turns in the direction shown in
the drawling.
9. Reinstall the above parts following the removal
steps in reverse.
Note:
• Be sure to install the paper feed roller unit [1]
so that the actuator section [2] coincides with
the detection section of the PS47 (no paper
sensor /BP) [3].
• Be sure to install the paper feed roller unit [1]
so that the tip end of the paper feed side of
the paper up/down lever comes into contact
with the inside of the top plate of the paper
feed roller unit [1].
[2]
[3]
[4]
1-67
BY-PASS TRAY
[3]
[4]
[1]
8050ma3077
[4]
[2]
[1]
8050ma3078
[3]
[2]
[1]
8050ma3079
Advertisement
Table of Contents
