Table of Contents
Advertisement
CF5001 Field Service Ver.1.0 Sep 2003
2.3
Connecting the CF5001
The ISW connector is hidden under the drum
cover. Detach this cover to run ISW.
A. Procedure
(1) Loosen 4 screws [1] and remove the side cover/
2 [2]
[1]
(2) Connect the PC port and the copier ISW con-
nector with interface cable.
IEEE1284 port
PC
USB (TypeB) port
Interface
cable
Note:
• Before performing ISW via USB, be sure to
turn on the USB radio button in [Setting (S)] -
[Set Communication (C)] in ISWTrns and
press the OK button.
2.4
2.4.1
Step
[2]
10
3-15
UPDATING WITH ISW Trns
Updating
Update operation overview
Follow the steps below to update the ROM data
on each control board using ISW Trns. For
more operational details, see the relevant parts
of this section.
Procedure
1
Check the ROM version of the copier before
proceeding with updating.
(See 2.4.2 "Checking the ROM version of
the copier (before updating).")
2
Run the ISW Trns program.
(See 2.4.4 "Running ISW Trns.").
3
Set the copier in ISW receive mode.
(See 2.4.3 "Preparing the copier to trans-
fer.")
4
Select conditions for transfer files (update
data) with IWS Trns. (See 2.4.5 "Selecting
transfer file (update data) conditions.")
5
Select a version of transfer files (update
data) with IWS Trns. (See 2.4.6 "Selecting a
version of transfer files (update data).")
6
Verify the transfer files (update data)
selected with IWS Trns. (See 2.4.7"Verify-
ing transfer files (update data)."
7
Transmit the transfer files (update data) with
IWS Trns. (See 2.4.8 "Transmitting transfer
files (update data).")
8
To update ROM data on more control
boards, repeat Steps 3 to 7.
9
Exit the ISW Trns program.
(See 2.4.9 "Exiting ISW Trns.")
Verify the ROM version of the copier after
updating. (See 2.4.10 "Verifying the ROM
version of the copier (after updating).")
Advertisement
Table of Contents
